CleanAir Analytical Benefits

Problem or Need Service	CleanAir's System	What To Look For	Bias Error or Risk	Benefit or Possible Outcome
Project specific full calibrations for each analyte. (Some labs use a single point calibration for a correction factor that is then used with an old full calibration.	Full instrument calibration immediately before and immediately after sample analysis for every project. All calibration data are included in our report.	Look for the full calibration dates listed on the calibration page.		Single point calibrations can produce bad results with no evidence of error.
Many methods only require three calibration points to generate a curve. This is the bare minimum for establishing a straight-line relationship.	>All of our calibration curves include at least one more point than required by method. This is a minimum of four calibration points with a coefficient of regression (R²) value greater than 0.995.	Calibration curves and least-squares regression data. Look for coefficient of regression (R²) greater than 0.995	With an R² of 0.995 or greater, the possible error is around 0.5%. A lower R² value suggests a greater possibility of error.	The calibration curve is not very accurate or precise when the R² value is under 0.995.
Sample Contamination	We minimize lab contamination by limiting our analysis services to relatively clean air samples.
Samples may not fall within the concentration range the instrument was calibrated for.	Calibration curves are customized to each project, minimizing the need for diluting samples	That the calibration curve brackets all reported concentrations for the samples.	Note: sample dilution may be required, but should be kept to a minimum.	Diluting samples can introduce error into the analysis
Humidity and temperature control
Customer may not be able to reach lab personnel to ask questions regarding: Status of samples, questions about analysis technique, etc.	We publish our chemist's cell phone numbers so questions can be answered quickly	Contact information page on our web site (email, phone, fax, cell phone).	NA	Not reaching the lab might mean the wrong analyses are performed, etc.
Satisfaction	110% money back guarantee on the accuracy and reliability of our results.	Guarantee is posted on our web site.	NA	Happiness
Problem or Need Schedule	CleanAir's System	What To Look For	Bias Error or Risk	Benefit or Possible Outcome

	I	.
Problem or Need Safety	CleanAir's System	What To Look For	Bias Error or Risk	Benefit or Possible Outcome
Fume hood safety	.	.	..	.
.	.	.	.	.
.	.	.	.	.
.	.	.	.	.
Problem or Need Trust	CleanAir's System	What To Look For	Bias Error or Risk	Benefit or Possible Outcome
	Locked labs with key card access limited to those that have a need for lab access.	.	.	.
Ethical Standards	Strong corporate wide commitment to the ethical standards of our profession	.	.	.
.	.	.	.	.
Problem or Need Value	CleanAir's System	What To Look For	Bias Error or Risk	Benefit or Possible Outcome
	We can develop procedures for analyses that do not have clearly stated methods.	Attempts to use methods not intended for the analytes/sample matrices	Unknown error	Integrity or lack there of when certifying emissions
Quality Reporting	Reports include all raw data and sample calculations, so clients can overlook every aspect of the analysis	All raw data, chromatograms, sample calculations, etc.		Inaccurate data.

To Speak To A Chemist Call 800-627-0033		Analytical Services

www.cleanair.com © 2005 Clean Air Engineering, All Rights Reserved Web site and legal information


	The CleanAir Quality System
		We have similiar benefit lists for: Stack Testing - Instrument Rental - Express Equipment Sales - Consulting Services - Analytical Services - Engine Services - Flow CEM - Instrument Repair & SCR Tuning *Use the table slide bar to see more benefits*